Construction of inlay axial surface using B-Spline curve network
- VernacularTitle:以三维B样条曲线网格构建嵌体轴面
- Author:
Mingli LIU
;
Yong WANG
;
Peijun LV
- Publication Type:Journal Article
- Keywords:
Computer aided design;
Imaging,three-dimensional;
inlays
- From:
Journal of Peking University(Health Sciences)
2003;0(04):-
- CountryChina
- Language:Chinese
-
Abstract:
Objective: To realize the requirement of adjacent area accuracy,axial surface physical contour and smoothness in the process of inlay computer-aided design(CAD).Methods:A compromised method was brought forward that some assistant 3-D constraint lines from occlusion to gingiva were used to lead the inlay contour on axial corner and other characterized areas,and two perpendicular 3-D constructing lines at adjacent area were used to construct accurate 3-D configuration of this area.The axial surface was completely defined by the network of specified curves which were two constructing lines and four borders.Results:Inlay axial surface was smooth,the contour was consistent with the residual tooth body and the 3-D configuration in adjacent area was accurate.Conclusion:It is feasible to realize the inlay axial surface accuracy,smoothness,and consistency using the method of special distributed 3-D B-Spline curve network.