Preparation, transfer property and biocompatibility of the hollow fiber dialysis membrane
10.3969/j.issn.2095-4344.2017.02.019
- VernacularTitle:中空纤维透析膜制备、传递特性及生物相容性
- Author:
Shiying WANG
;
Xinxin ZHAO
;
Jun SHI
;
Suxia YANG
;
Zhiqiang SUN
- From:
Chinese Journal of Tissue Engineering Research
2017;21(2):268-272
- CountryChina
- Language:Chinese
-
Abstract:
BACKGROUND:Polysulfone membrane holds good anti-biodegradation ability, but how to use it to prepare hol ow fiber dialysis membrane and its blood compatibility have not been ful y understood. OBJECTIVE:To study the preparation, transfer property and biocompatibility of hol ow fiber dialysis membrane. METHODS:With polysulfone as the film material, diethylene glycol as the porogen, polyvinyl pyrrolidone as the modifier, N, N-dimethylacetamide as the solvent, and the hol ow fiber dialysis membrane was prepared using nonsolvent-induced phase separation. The performance was measured using scanning electron microscopy, ultra-depth three-dimensional microscope imaging and porosity test;the transfer parameters including reject rate and water flux were detected by ultrafiltration device;the blood compatibility was determined through hemolysis test, dynamic clotting time test and platelet adhesion test. Type II medical polyurethane material served as negative control. RESULTS AND CONCLUSION:The section of hol ow fiber dialysis membrane was asymmetric. 17%dialysis membrane showed a porous middle layer, while 19%, 21%and 23%membrane showed a sponge-like middle layer. Under the same membrane area, the density of fiber dialysis membrane was significantly lower than that of the negative control material, and the porosity of fiber dialysis membrane was significantly higher than that of the negative control material (P<0.05). The water volume and water flux of the hol ow fiber dialysis membrane were significantly higher than those of the negative control material (P<0.05). Results from three hemolytic tests showed that the average absorbance values and hemolysis rate of the hol ow fiber dialysis membrane were significantly higher than those of the negative control material (P<0.05). The dynamic clotting time test and the platelet adhesion test revealed that the dynamic clotting time of hol ow fiber dialysis membrane at 20, 40 and 70 minutes was significantly shorter than that of the negative control material (P<0.05). These results suggest that polysiloxane can be used as the membrane material to prepare hol ow fiber dialysis membrane using nonsolvent-induced phase separation, and holds a good biocompatibility, blood compatibility and transfer efficiency.
