Establishment of a rat model of blood hypercoagulable state caused by intravenous injection of thrombin
10.3969/j.issn.1005-4847.2016.06.016
- VernacularTitle:凝血酶法致大鼠血液高凝态模型的建立
- Author:
Liwen WANG
;
Xiaojie SHEN
;
Qian WU
;
Yingying JI
;
Guoqing GONG
- Keywords:
Rat;
Hypercoagulable state;
Thrombin;
Intravenous injection;
Femoral vein
- From:
Acta Laboratorium Animalis Scientia Sinica
2016;24(6):639-642
- CountryChina
- Language:Chinese
-
Abstract:
Objective The aim of this study was to establish a rat model of blood hypercoagulable state by intra?venous injection of thrombin and to provide a model for researches on hypercoagulable state. Methods Rats were divided into six groups and were injected with normal saline and 2?5, 5, 10, 20, 40 U/kg thrombin solution through the femoral vein, respectively. Then, blood was drawn to test the activated partial thromboplastin time (APTT), prothrombin time ( PT) and fibrinogen ( FIB) , and to observe the death rate of rats in these groups to verify the optimal dosage. On this ba?sis, rats were injected thrombin of the best dose through the femoral vein, and blood samples were collected at 0, 10, 30, 60, 120, 180, 300 (s) to test APTT and PT and FIB for determining the best time for blood sampling. At last, the rats were divided into control group and thrombin group to inject normal saline or thrombin solution in the best dose via the fem?oral vein, and blood was taken at the best time to test APTT, PT, FIB and whole blood viscosity. Results APTT and PT values of the 10 U/kg thrombin group were the shortest, and FIB value of this group was the highest among these groups. APTT and PT values of blood sample collected at about 60 s after thrombin injection were the shortest, and FIB value was the highest. Compared with the control group, PT and APTT values of the thrombin group were shorter (P<0?05), and blood viscosity and FIB were higher ( P<0?05 ) . Conclusions Injecting thrombin solution into the femoral vein can be used to establish a rat model of hypercoagulable state. The best dose of thrombin solution is 10 U/kg in a concentration of 2 U/mL. The best time to collect blood sample is 60 s.