High resolution MR imaging of porcine coronary arterial wall in vitro
- VernacularTitle:猪体外冠状动脉管壁高分辨MR成像
- Author:
Tao LI
;
Jianhua GAO
;
Shaohong ZHAO
;
Weihua ZHOU
;
Zulong CAI
;
Li YANG
;
Liuquan CHENG
;
Yuangui GAO
- Publication Type:Journal Article
- Keywords:
Coronary vessels;
Magnetic resonance imaging
- From:
Chinese Journal of Medical Imaging Technology
2010;26(4):589-592
- CountryChina
- Language:Chinese
-
Abstract:
Objective To get a MR imaging protocol for coronary arterial wall in vitro. Methods MR examinations were performed in 10 fresh porcine hearts. Three dimensional fast imaging employing steady state acquisition (3D FIESTA) was used to delineate left anterior descending artery (LAD), while 2D spin-echo T1W was performed with 8-channel head surface coil, temporomandibular surface coil and knee coil with the same parameters. T1WI was obtained with 384×256 and 512×512 in matrix using temporomandibular surface coil, and then T1WI, PDW and T2WI with fat saturation were obtained with different NEX using temporomandibular surface coil after injecting Resovist in LAD. Signal of the LAD wall, lumen, fat tissue adjacent to LAD, myocardium of anterior part of interventricular septum and noise were respectively measured. Signal-to-noise ratio (SNR) of image, contrast to noise ratio (CNR) between the wall and lumen (CNR1), CNR between the wall and surrounding fatty tissue (CNR2) were calculated. Results The SNR and CNR1, CNR2 of SE T1WI with temporomandibular coil were higher than those with 8-channel head surface coil and knee coil. SNR and CNR1, CNR2 of SE T1WI with 384×256 matrix were higher than those with 512×512 matrix. SNR and CNR1, CNR2 using 3 NEX were the highest. Conclusion Good SNR and CNR of porcine coronary wall can be achieved using temporomandibular surface coil, 384×256 in matrix and NEX of 3.
