Surface analyses of titanium substrate modified by anodization and nanoscale Ca-P deposition.
- Author:
Joung Min LEE
1
;
Chang Whe KIM
;
Young Jun LIM
;
Myung Joo KIM
Author Information
1. Department of Prosthodontics, Graduate School, Seoul National University, Korea.
- Publication Type:Original Article
- Keywords:
Ion beam-assisted deposition;
Calcium phosphate;
Anodic oxidation;
Surface characteristics;
Wettability
- MeSH:
Calcium;
Crystallins;
Hydrophobic and Hydrophilic Interactions;
Osseointegration;
Oxides;
Titanium*;
Water;
Wettability;
X-Ray Diffraction
- From:The Journal of Korean Academy of Prosthodontics
2007;45(6):795-804
- CountryRepublic of Korea
- Language:English
-
Abstract:
STATEMENT OF PROBLEM: Nano-scale calcium-phosphate coating on the anodizing titanium surface using ion beam-assisted deposition (IBAD) has been recently introduced to improve the early osseointegration. However, not much is known about their surface characteristics that have influence on tissue-implant interaction. PURPOSE. This study was aimed to investigate microtopography, surface roughness, surface composition, and wettability of the titanium surface modified by the anodic oxidation and calcium phosphate coating using IBAD. MATERIAL AND METHODS: Commercially pure titanium disks were used as substrates. The experiment was composed of four groups. Group MA surfaces represented machined surface. Group AN was anodized surface. Group CaP/AN was anodic oxidized and calcium phosphate coated surfaces. Group SLA surfaces were sandblasted and acid etched surfaces. The prepared titanium discs were examined as follows. The surface morphology of the discs was examined using SEM. The surface roughness was measured by a confocal laser scanning microscope. Phase components were analyzed using thin-film x-ray diffraction. Wettability analyses were performed by contact angle measurement with distilled water, formamide, bromonaphtalene and surface free energy calculation. RESULTS: (1) The four groups showed specific microtopography respectively. Anodized and calcium phosphate coated specimens showed multiple micropores and tiny homogeneously distributed crystalline particles (2) The order of surface roughness values were, from the lowest to the highest, machined group, anodized group, anodized and calcium phosphate deposited group, and sandblasted and acid etched group. (3) Anodized and calcium phosphate deposited group was found to have titanium and titanium anatase oxides and exhibited calcium phosphorous crystalline structures. (4) Surface wettability was increased in the order of calcium phosphate deposited group, machined group, anodized group, sandblasted and acid etched group. CONCLUSION: After ion beam-assisted deposition on anodized titanium, the microporous structure remained on the surface and many small calcium phosphorous crystals were formed on the porous surface. Nanoscale calcium phosphorous deposition induced roughness on the microporous surface but hydrophobicity was increased.
