Analysis of electron beam output factors by Monte Carlo method
10.3760/cma.j.issn.1004-4221.2014.03.023
- VernacularTitle:基于蒙特卡洛方法研究电子线输出因子影响因素
- Author:
Zifeng CHI
;
Dan LIU
;
Yong ZHANG
;
Runxiao LI
;
Zhonghao JING
;
Feng FENG
;
Chun HAN
- Publication Type:Journal Article
- Keywords:
Electronbeam irradiation;
Output factor;
Monte Carlo method
- From:
Chinese Journal of Radiation Oncology
2014;23(3):265-268
- CountryChina
- Language:Chinese
-
Abstract:
Objective To investigate the application of the Monte Carlo dose calculation of output factors for electron beams in radiotherapy.Methods The code EGS4/MCTP was used to simulate the head of a medical linear accelerator (Varian 23EX) to calculate the output factors for 6 MeV,9 MeV and 18 MeV electron beams.The source-to-surface distance used was 100 cm.The field sizes ranged from 2 cm × 2 cm to 25 cm × 25 cm.The calculated output factors agreed with the corresponding measured factors which were measured by the IBA Phantom system to within 2％.Then,the output factors of direct articles and indirect articles which were under different energy and various cone-insert combinations were calculated by the code EGS4/MCTP.Results The calculated output factors agreement with the measurements is found to be mostly under the 1％ level.The variation of output factors depends on the characteristics of the beams and the modifications that the various cone-insert combinations introduce to these characteristics.Conclusions Monte Carlo dose calculations for electron beams in homogeneous water phantoms have been demonstrated to be accurate under the 1％ level in comparison with measurements.The output factors were influenced by energy and cone-insert combinations in complex ways.
