The measurement of convergence angles of the fixed denture
- VernacularTitle:固定义齿基牙聚合角的测量与讨论
- Author:
Shu JIANG
;
Zhongyi WANG
- Publication Type:Journal Article
- From:
Journal of Practical Stomatology
2001;17(2):138-140
- CountryChina
- Language:Chinese
-
Abstract:
Objective: To measure the convergence angles of teeth in different teeth positions and different denture designs.Methods:Mesio-distal widths and labio-lingual widths were measured on 226 teeth according to three points in a line on three surfaces (gingival, middle and incise) of each tooth.The distance between every point and the counterpart point in the adjacent surface was measured.Then convergence angles were calculated. Results:The means of the angles were 4.13°±0.77°,4.14°±0.76°, 4.46°±0.95°, 4.76°±0.84° on the first and second premolar, the first and second molar,respectively . There were significant differences between the premolars and molars(P<0.05).On the dentures with the designs of monocrown, triunit-bridge and long bridge the means of the angles were 3.78°±0.74°,4.69°±0.75° and 5.08°±0.85° respectively,the angle on the denture with the design of monocrown was smaller than that of bridge (P<0.05).Conclusion:The convergence angles are different according to different teeth positions and different denture designs, so they should be adjusted according to the clinical requirements.
