Finite element analysis on point contact locking plate fixating femoral shaft fractures
10.3760/cma.j.issn.1001-8050.2009.03.74
- VernacularTitle:点接触锁定接骨板固定股骨干骨折的三维有限元分析
- Author:
Yan XIONG
;
Yufeng ZHAO
;
Xiansheng GONG
;
Jianglin HU
;
Ziming WANG
;
Qnanyin DU
;
Hongzhen SUN
;
Siyu WU
;
Aimin WANG
- Publication Type:Journal Article
- Keywords:
Internal fixator;
Femoral fracture;
Biomecharrics;
Finite element analysis
- From:
Chinese Journal of Trauma
2009;25(3):245-248
- CountryChina
- Language:Chinese
-
Abstract:
Objective To set up a three-dimensional finite element model (FEM) to investigate biomechanics of point contact locking plate (PC-LP) fixating femoral shaft fractures. Methods One intact fresh adult cadaveric femur was scanned by CT at 1 mm interval. Then, the data of CT were utilized to establish three-dimensional FEM by using software Mimics and PRO/E and simulate the different clini-cal loading conditions. The changes of theoretical stress of femur and PC-LP were analyzed under flexion, axial compression and torsion loads. Results (1) Under four-point bending load, the distribution of femur stress was in uniformity, with the largest stress of the PC-LP focused on the edge. (2) Under axial compression load of 250 N, the largest stress of the femur was focused on the screw holes on beth distal ends, with the largest stress of the PC-LP focused on the middle screw holes. (3) Under the torsion load cused on the middlepart and the middle screw holes. Conclusions Under the four-point bending, ax-ial compression and torsion loads, the distribution of femur stress is in uniformity, when the largest stress of the PC-LP focuses on edge or the middle screw holes, while that of the PC-LP on two screw holes of proximal or distal ends.
