Influence of acrylamide monomer addition to the acrylic denture-base resins on mechanical and physical properties.
10.1038/ijos.2013.69
- Author:
Elif Aydogan AYAZ
;
Rukiye DURKAN
- Publication Type:Journal Article
- MeSH:
Acrylamide;
chemistry;
Acrylic Resins;
chemistry;
Dental Materials;
chemistry;
Denture Bases;
Elastic Modulus;
Hot Temperature;
Humans;
Magnetic Resonance Spectroscopy;
Materials Testing;
Microwaves;
Pliability;
Polymerization;
Polymethyl Methacrylate;
chemistry;
Powders;
Solutions;
Stress, Mechanical;
Thermodynamics;
Thermogravimetry;
Time Factors
- From:
International Journal of Oral Science
2013;5(4):229-235
- CountryChina
- Language:English
-
Abstract:
The aim of the study was to evaluate the effect of adding acrylamide monomer (AAm) on the characterization, flexural strength, flexural modulus and thermal degradation temperature of poly(methyl methacrylate) (PMMA) denture-base resins. Specimens (n=10) were fabricated from a conventional heat-activated QC-20 (Qc-) and a microwave heat-activated Acron MC (Ac-) PMMA resins. Powder/liquid ratio followed the manufacturer's instructions for the control groups (Qc-c and Ac-c) and for the copolymer groups, the resins were prepared with 5% (-5), 10% (-10), 15% (-15) and 20% (-20) acrylamide contents, according to the molecular weight ratio, respectively. The flexural strength and flexural modulus were measured by a three-point bending test. The data obtained were statistically analyzed by Kruskal-Wallis test (α=0.05) to determine significant differences between the groups. The chemical structures of the resins were characterized by the nuclear magnetic resonance spectroscopy. Thermal stabilities were determined by thermogravimetric analysis (TGA) with a heating rate of 10 °C⋅min(-1) from 35 °C to 600 °C. Control groups from both acrylic resins showed the lowest flexural strength values. Qc-15 showed significant increase in the flexural strength when compared to Qc-c (P<0.01). Ac-10 and Ac-15 showed significance when compared to Ac-c (P<0.01). Acrylamide incorporation increased the elastic modulus in Qc-10, Qc-15 and Qc-20 when compared to Qc-c (P<0.01). Also significant increase was observed in Ac-10, Ac-15 and Ac-20 copolymer groups when compared to Ac-c (P<0.01). According to the (1)H-nuclear magnetic resonance (NMR) results, acrylamide copolymerization was confirmed in the experimental groups. TGA results showed that the thermal stability of PMMA is increased by the insertion of AAm.
