Surface roughness of zirconia for full-contour crowns after clinically simulated grinding and polishing.
- Author:
Rim HMAIDOUCH
1
;
Wolf-Dieter MÜLLER
2
;
Hans-Christoph LAUER
1
;
Paul WEIGL
3
Author Information
- Publication Type:Journal Article
- MeSH: Aluminum Silicates; chemistry; Ceramics; chemistry; Crowns; Dental Materials; chemistry; Dental Polishing; instrumentation; methods; Dental Prosthesis Design; Dental Veneers; Diamond; chemistry; Humans; Materials Testing; Microscopy, Electron, Scanning; Particle Size; Potassium Compounds; chemistry; Pressure; Surface Properties; Time Factors; Water; chemistry; Yttrium; chemistry; Zirconium; chemistry
- From: International Journal of Oral Science 2014;6(4):241-246
- CountryChina
- Language:English
- Abstract: The aim of this study was to evaluate the effect of controlled intraoral grinding and polishing on the roughness of full-contour zirconia compared to classical veneered zirconia. Thirty bar-shaped zirconia specimens were fabricated and divided into two groups (n=15). Fifteen specimens (group 1) were glazed and 15 specimens (group 2) were veneered with feldspathic ceramic and then glazed. Prior to grinding, maximum roughness depth (Rmax) values were measured using a profilometer, 5 times per specimen. Simulated clinical grinding and polishing were performed on the specimens under water coolant for 15 s and 2 N pressure. For grinding, NTI diamonds burs with grain sizes of 20 µm, 10 µm, and 7.5 µm were used sequentially. The ground surfaces were polished using NTI kits with coarse, medium and fine polishers. After each step, Rmax values were determined. Differences between groups were examined using one-way analysis of variance (ANOVA). The roughness of group 1 was significantly lower than that of group 2. The roughness increased significantly after coarse grinding in both groups. The results after glazing were similar to those obtained after fine grinding for non-veneered zirconia. However, fine-ground veneered zirconia had significantly higher roughness than venerred, glazed zirconia. No significant difference was found between fine-polished and glazed zirconia, but after the fine polishing of veneered zirconia, the roughness was significantly higher than after glazing. It can be concluded that for full-contour zirconia, fewer defects and lower roughness values resulted after grinding and polishing compared to veneered zirconia. After polishing zirconia, lower roughness values were achieved compared to glazing; more interesting was that the grinding of glazed zirconia using the NTI three-step system could deliver smooth surfaces comparable to untreated glazed zirconia surfaces.
