OBJECTIVETo evaluate the influence of the frequency, the weight and the motion angle on the stress and the fatigue of the forearm extensors in repetitive wrist extending at low force loading level with surface electromyography (SEMG).

METHODSSixteen male college student volunteers were recruited for the experiment. Eight tasks of wrist extending were performed for 20 minutes respectively in given weight (1.96, 4.90 N), frequency (8.0, 33.3 moves/minute) and motion angle (45 degrees, 90 degrees). The static wrist extending at the level of 20% maximum voluntary contraction (MVC) were performed before and after each task for 2 up to 3 seconds, and the SEMG signals of extensor carpi ulnaris muscle (ECU) and extensor digitorum (ED) were recorded and analyzed.

RESULTSThe weight loading level was approximately equal to 1.40% or 3.50% of the MVC force. The mean power frequency (MPF) and the median frequency (MF) were decreased with the increase of 3 kinds of loading levels. The decrease of MPF of the muscle ED was significant (P < 0.05 or P < 0.01). The MF was decreased with the increase of angle and weight loading levels (P < 0.05 or P < 0.01). The root mean square (RMS) value of SEMG could be divided into 3 or 4 groups with significant difference. All three kinds of loads had positive correlation with amplitude of SEMG according to the stepwise regression analysis.

CONCLUSIONThe fatigue level of ED is the highest. The primary load factor for the forearm extensors is the frequency followed by the weight and the angle. MF, MPF and RMS can be used as sensitive indexes for evaluating the stress and the fatigue of the forearm extensors during repetitive performance at lower force loading level.