OBJECTIVETo evaluate in vitro the microtensile bond strengths of three dentin adhesive systems and their respective fracture modes.

METHODSA total of 15 intact young human premolars extracted for orthodontic reasons were used. The enamel of occlusal surfaces of these premolar teeth was removed and superficial dentine was exposed, finished with wet 600-grit silicon carbide paper. And then these teeth were randomly divided into three groups. A block of composite resin was bonded respectively with three dentin adhesive systems: All-bond 2 (Group AB(2)), Fluoro-Bond (Group FB) and Xeno III (Group Xeno) according to manufacturers' instructions. The bonded teeth were kept in distilled water for 24 h at 37 degrees C. The roots were removed from the remaining crown approximately 1 - 2 mm below the cemento-enamel junction with a slow-speed diamond saw. The teeth were sectioned to obtain bar-shaped specimens, whose bonded surface areas were about 0.8 mm(2). The specimens were stressed at a crosshead speed of 1 mm/min until rupture of the bond. SEM was used to observe the fracture modes. The mean bond strengths were compared using one-way ANOVA and LSD tests. The frequency of fracture modes was compared using Krukal-Wallis and Mann-Whitney U-test.

RESULTSMean microtensile bond strengths were (29.56 +/- 5.47) MPa for Group AB(2), (15.81 +/- 7.67) MPa for Group Xeno, and (14.61 +/- 4.50) MPa for Group FB. The bond strength of Group AB(2) was greater than those of the other two groups (P < 0.01). The bond strengths of Group Xeno and Group FB were not significantly different. SEM examination indicated that the adhesive failure was the most mode of fracture.

CONCLUSIONSThe microtensil bond strengths of three dentin adhesive systems to normal human dentine were different and the total-etching adhesive All-Bond 2 exhibited the greatest bond strength. It was recommended that dentin adhesive agent should be used according to clinical situation.