Three-dimensional finite element modeling of a maxillary premolar tooth based on the micro-CT scanning: a detailed description.
10.1007/s11596-013-1196-6
- Author:
Zheng HUANG
1
;
Zhi CHEN
2
Author Information
1. Key Laboratory for Oral Biomedicine of Ministry of Education, School and Hospital of Stomatology, Wuhan University, Wuhan, 430079, China.
2. Key Laboratory for Oral Biomedicine of Ministry of Education, School and Hospital of Stomatology, Wuhan University, Wuhan, 430079, China. ZhiChen@whu.edu.cn.
- Publication Type:Journal Article
- MeSH:
Bicuspid;
diagnostic imaging;
physiology;
Biomechanical Phenomena;
Finite Element Analysis;
Humans;
Image Processing, Computer-Assisted;
Imaging, Three-Dimensional;
methods;
Maxilla;
Models, Anatomic;
Software;
Stress, Mechanical;
Weight-Bearing;
physiology;
X-Ray Microtomography;
methods
- From:
Journal of Huazhong University of Science and Technology (Medical Sciences)
2013;33(5):775-779
- CountryChina
- Language:English
-
Abstract:
This study describes the details of how to construct a three-dimensional (3D) finite element model of a maxillary first premolar tooth based on micro-CT data acquisition technique, MIMICS software and ANSYS software. The tooth was scanned by micro-CT, in which 1295 slices were obtained and then 648 slices were selected for modeling. The 3D surface mesh models of enamel and dentin were created by MIMICS (STL file). The solid mesh model was constructed by ANSYS. After the material properties and boundary conditions were set, a loading analysis was performed to demonstrate the applicableness of the resulting model. The first and third principal stresses were then evaluated. The results showed that the number of nodes and elements of the finite element model were 56 618 and 311801, respectively. The geometric form of the model was highly consistent with that of the true tooth, and the deviation between them was -0.28%. The loading analysis revealed the typical stress patterns in the contour map. The maximum compressive stress existed in the contact points and the maximum tensile stress existed in the deep fissure between the two cusps. It is concluded that by using the micro-CT and highly integrated software, construction of the 3D finite element model with high quality will not be difficult for clinical researchers.
