Effect of two-phase fabrication method for the optimum fit of light-polymerized record bases.
- Author:
Jung Bo HUH
1
;
Min Goo KANG
;
Sang Wan SHIN
;
Jae Jun RYU
Author Information
- Publication Type:Original Article
- Keywords: Record base; Two-stage polymerization; Fit
- MeSH: Collodion; Denture Bases; Fingers; Maxilla; Phenothiazines; Polymers; Silicones
- From:The Journal of Advanced Prosthodontics 2010;2(3):102-105
- CountryRepublic of Korea
- Language:English
- Abstract: PURPOSE: The aims of this study were to suggest a method of fabrication of the record base using a light-polymerized resin by applying the two-phase fabrication method for the improvement of the fit of the record base and to compare the degree of fit according to the separation site. MATERIAL AND METHODS: In the edentulous cast of maxilla, four test groups were considered. In the first, second, third, and fourth test groups (n = 12 in each group) the separation was done at 0, 5, 10, and 15 mm, respectively below the alveolar crest along the palatal plane. For the control group, the record base was made without separating the two sections. The light-body silicone material was injected into the fitting surface of the record base. It was then placed onto the cast and finger pressure was applied to stabilize it in a seated position followed by immediate placement onto the universal test device. Finally, the mass of the impression material was measured after it was removed. ANOVA was performed using the SAS program. For the post-hoc test, the Wilcoxon Rank-Sum test and the Tukey-Kramer HSD test were performed (alpha = 0.05). RESULTS: The control group and Group 3, 4 showed significant differences. The Group 3 and 4 showed significantly smaller inside gaps than the control group which was not made with the two-phase fabrication method. CONCLUSION: The two-stage polymerized technique can improve the fit of the denture base particularly when the separation was made at 10 to 15 mm from the alveolar crest.
