Depositional characteristics of atmospheric polybrominated diphenyl ethers on tree barks.
10.5620/eht.2014.29.e2014003
- Author:
Man Young CHUN
1
Author Information
1. Department of Environmental Engineering, Hankyong National University, Anseong, Korea.
- Publication Type:Original Article
- Keywords:
Atmospheric PBDEs;
Lipid content;
Passive air sampler;
Tree barks
- MeSH:
Ginkgo biloba;
Halogenated Diphenyl Ethers*;
Plant Bark*;
Trees
- From:Environmental Health and Toxicology
2014;29(1):e2014003-
- CountryRepublic of Korea
- Language:English
-
Abstract:
OBJECTIVES: This study was conducted to determine the depositional characteristics of several tree barks, including Ginkgo (Ginkgo biloba), Pine (Pinus densiflora), Platanus (Platanus), and Metasequoia (Metasequoia glyptostroboides). These were used as passive air sampler (PAS) of atmospheric polybrominated diphenyl ethers (PBDEs). METHODS: Tree barks were sampled from the same site. PBDEs were analyzed by highresolution gas chromatography/high-resolution mass spectrometer, and the lipid content was measured using the gravimetric method by n-hexane extraction. RESULTS: Gingko contained the highest lipid content (7.82 mg/g dry), whereas pine (4.85 mg/g dry), Platanus (3.61 mg/g dry), and Metasequoia (0.97 mg/g dry) had relatively lower content. The highest total PBDEs concentration was observed in Metasequoia (83,159.0 pg/g dry), followed by Ginkgo (53,538.4 pg/g dry), Pine (20,266.4 pg/g dry), and Platanus (12,572.0 pg/g dry). There were poor correlations between lipid content and total PBDE concentrations in tree barks (R2=0.1011, p =0.682). Among the PBDE congeners, BDE 206, 207 and 209 were highly brominated PBDEs that are sorbed to particulates in ambient air, which accounted for 90.5% (84.3-95.6%) of the concentration and were therefore identified as the main PBDE congener. The concentrations of particulate PBDEs deposited on tree barks were dependent on morphological characteristics such as surface area or roughness of barks. CONCLUSIONS: Therefore, when using the tree barks as the PAS of the atmospheric PBDEs, samples belonging to same tree species should be collected to reduce errors and to obtain reliable data.
