Influence of crestal module design on marginal bone stress around dental implant.
10.4047/jkap.2010.48.3.224
- Author:
Jung Yoel LIM
1
;
Jin Hyun CHO
;
Kwang Heon JO
Author Information
1. Department of Prosthodontics, School of Dentistry, Kyungpook National University, Daegu, Korea. khjo@knu.ac.kr
- Publication Type:Original Article
- Keywords:
Crestal module design;
Trans-gingival module;
Marginal bone stress
- MeSH:
Axis, Cervical Vertebra;
Dental Implants;
Implants, Experimental
- From:The Journal of Korean Academy of Prosthodontics
2010;48(3):224-231
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
PURPOSE: This study was to investigate how the crestal module design could affect the level of marginal bone stress around dental implant. MATERIALS AND METHODS: A submerged implant of 4.1 mm in diameter and 10 mm in length was selected as baseline model (Dentis Co., Daegu,Korea).A total of 5 experimental implants of different crestal modules were designed (Type I model : with microthread at the cervical 3 mm, Type II model : the same thread pattern as Type I but with a trans-gingival module, Type III model: the same thread pattern as the control model but with a trans-gingival module, Type IV model: one piece system with concave transgingival part, Type V model: equipped with beveled platform). Stress analysis was conducted with the use of axisy mmetric finite element modeling scheme. A force of 100 N was applied at 30 degrees from the implant axis. RESULTS: Stress analysis has shown no stress concentration around the marginal bone for the control model. As compared to the control model, the stress levels of 0.2 mm areas away from the recorded implant were slightly lower in Type I and Type IV models, but higher in Type II, Type III and Type V models. As compared to 15.09 MPa around for the control model, the stress levels were 14.78 MPa, 18.39 MPa, 21.11 MPa, 14.63 MPa, 17.88 MPa in the cases of Type I, II, III, IV and V models. CONCLUSION: From these results, the conclusion was drawn that the microthread and the concavity with either crestal or trans-gingival modules maybe used in standard size dental implants to reduce marginal bone stress.
