Shear bond strength of self-etching adhesives to dentin and sem analysis.
10.5395/JKACD.2003.28.3.222
- Author:
Young Gon CHO
1
;
Kee Sun ROH
;
Soo Mee KIM
;
Young Gon LEE
;
Jin Ho JEONG
;
Young Jae KI
Author Information
1. Department of Conservative Dentistry, College of Dentistry, Chosun University, Korea. ygcho@mail.chosun.ac.kr
- Publication Type:Original Article
- Keywords:
Shear bond strength;
Self-etching adhesive;
SEM analysis;
Failure mode;
Interfacial patterns;
Composite
- MeSH:
Adhesives*;
Dentin*;
Humans;
Molar
- From:Journal of Korean Academy of Conservative Dentistry
2003;28(3):222-231
- CountryRepublic of Korea
- Language:Korean
-
Abstract:
The purpose of this study was to compare shear bond strength and interfacial pattern of composite bonded to dentin using self-etching adhesive systems. Sixty extracted human molars with exposed occlusal dentin were divided into four groups and bonded with four adhesives and composites: Single Bond/Filtek Z 250(SB), Tyrian SPE-One-Step Plus/Aelitefil(TY), Prompt L-Pop/Filtek Z 250(LP), and One-Up Bond F/Palfique Toughwell(OU). The results of this study were as follows; 1. Shear bond strength for OU was significantly lower than that of other groups(p<0.05). No significant difference was founded among SB, TY, and LP. 2. Failure modes to dentin showed adhesive and mixed for SB, TY, and LP, but them for OU showed adhesive in all spceimens. 3. Dentin-resin interface showed close adaptation for SB, TY, and LP, but it showed gap for OU. 4. The hybrid layers for TY, LP, OU were thinner than that of SB. Adhesive layers were observed between composite and hybrid layer, which were 5 microm thick for TY and 10 microm thick for OU.
