The effect of thermocycling on the bonding of different restorative materials to access opening through porcelain fused to metal restorations.
10.4047/jap.2011.3.4.186
- Author:
Mohammed M AL-MOALEEM
;
Farhan Khalid SHAH
;
Nausheen Saied KHAN
;
Amit PORWAL
- Publication Type:Original Article
- Keywords:
Porcelain fused to metal restorations;
Restorative dental materials;
Thermocycling effect
- MeSH:
Adhesives;
Aging;
Alloys;
Bacteria;
Crowns;
Dental Porcelain;
Dental Pulp Cavity;
Humans;
Tooth
- From:The Journal of Advanced Prosthodontics
2011;3(4):186-189
- CountryRepublic of Korea
- Language:English
-
Abstract:
PURPOSE: Porcelain fused to metal (PFM) crowns provide the best treatment option for teeth that have a large or defective restoration. More than 20% of teeth with PFM crowns or bridges require non-surgical root canal treatment (NSRCT). This may be due to the effect of restorative procedures and the possible leakage of bacteria and or their by-products, which leads to the demise of the tooth pulp. Thus, this study was planned to compare the ability of the restorative materials to seal perforated PFM specimens. MATERIALS AND METHODS: The study evaluates the ability of amalgam, composite or compomer restorative materials to close perforated PFM specimen's in-vitro. Ninety PFM specimens were constructed using Ni-Cr alloys and feldspathic porcelain, and then they were divided into 3 groups: amalgam (A), composite + Exite adhesive bond (B) and compomer + Syntac adhesive bond (C). All the PFM samples were embedded in an acrylic block to provide complete sealing of the hole from the bottom side. After the aging period, each group was further divided into 3 equal subgroups according to the thermocycling period (one week for 70 cycles, one month for 300 cycles and three months for 900 cycles). Each subgroup was put into containers containing dye (Pelikan INK), one maintained at 5degrees C and the other at 55degrees C, each cycle for 30 sec time. The data obtained was analyzed by SPSS, 2006 using one way ANOVA test and student t-test and significant difference level at (P<.01). RESULTS: The depth of dye penetration was measured at the interfaces of PFM and filling materials using Co-ordinate Vernier Microscope. The lowest levels of the dye penetration for the three groups, as well as subgroups were during the first week. The values of dye leakage had significantly increased by time intervals in subgroups A and C. CONCLUSION: It was seen that amalgam showed higher leakage than composite while compomer showed the lowest level of leakage.
