Advancements and Challenges in Robot-Assisted Bone Processing in Neurosurgical Procedures
- Author:
Yoshihiro KITAHAMA
1
;
Hiroo SHIZUKA
;
Yuto NAKANO
;
Yukoh OHARA
;
Jun MUTO
;
Shuntaro TSUCHIDA
;
Daisuke MOTOYAMA
;
Hideaki MIYAKE
;
Katsuhiko SAKAI
Author Information
- Publication Type:Original Article
- From: Neurospine 2024;21(1):97-103
- CountryRepublic of Korea
- Language:English
-
Abstract:
Objective:Practical applications of nerve decompression using neurosurgical robots remain unexplored. Our ongoing research and development initiatives, utilizing industrial robots, aim to establish a secure and efficient neurosurgical robotic system. The principal objective of this study was to automate bone grinding, which is a pivotal component of neurosurgical procedures.
Methods:To achieve this goal, we integrated an endoscope system into a manipulator and conducted precision bone machining using a neurosurgical drill, recording the grinding resistance values across 3 axes. Our study encompassed 2 core tasks: linear grinding, such as laminectomy, and cylindrical grinding, such as foraminotomy, with each task yielding unique measurement data.
Results:In linear grinding, we observed a proportional increase in grinding resistance values in the machining direction with acceleration. This observation suggests that 3-axis resistance measurements are a valuable tool for gauging and predicting deep cortical penetration. However, problems occurred in cylindrical grinding, and a significant error of 10% was detected. The analysis revealed that multiple factors, including the tool tip efficiency, machining speed, teaching methods, and deflection in the robot arm and jig joints, contributed to this error.
Conclusion:We successfully measured the resistance exerted on the tool tip during bone machining with a robotic arm across 3 axes. The resistance ranged from 3 to 8 Nm, with the measurement conducted at a processing speed approximately twice that of manual surgery performed by a surgeon. During the simulation of foraminotomy under endoscopic grinding conditions, we encountered a -10% error margin.
