Cervical spine reconstruction after total vertebrectomy using customized three-dimensional-printed implants in dogs
- Author:
Ji-Won JEON
1
;
Kyu-Won KANG
;
Woo-Keyoung KIM
;
Sook YANG
;
Byung-Jae KANG
Author Information
- Publication Type:Original Article
- From:Journal of Veterinary Science 2024;25(1):e2-
- CountryRepublic of Korea
- Language:EN
-
Abstract:
Background:Sufficient surgical resection is necessary for effective tumor control, but is usually limited for vertebral tumors, especially in the cervical spine in small animal neurosurgery.
Objective:To evaluate the primary stability and safety of customized three-dimensional (3D)-printed implants for cervical spine reconstruction after total vertebrectomy.
Methods:Customized guides and implants were designed based on computed tomography (CT) imaging of five beagle cadavers and were 3D-printed. They were used to reconstruct C5 after total vertebrectomy. Postoperative CT images were obtained to evaluate the safety and accuracy of screw positioning. After harvesting 10 vertebral specimens (C3–C7) from intact (group A) and implanted spines (group B), implant stability was analyzed using a 4-point bending test comparing with groups A and C (reconstituted with plate and pins/ polymethylmethacrylate after testing in Group A).
Results:All customized implants were applied without gross neurovascular damage. In addition, 90% of the screws were in a safe area, with 7.5% in grade 1 (< 1.3 mm) and 2.5% in grade 2 (> 1.3 mm). The mean entry point and angular deviations were 0.81 ± 0.43 mm and 6.50 ± 5.11°, respectively. Groups B and C significantly decreased the range of motion (ROM) in C3– C7 compared with intact spines (p = 0.033, and 0.018). Both groups reduced overall ROM and neutral zone in C4–C6, but only group B showed significance (p = 0.005, and 0.027).
Conclusion:Customized 3D-printed implants could safely and accurately replace a cervical vertebra in dog cadavers while providing primary stability.
