Effects of occlusal load on the cervical stress distribution: A three-dimensional finite element study.
10.5395/JKACD.2006.31.6.427
- Author:
Hyeong Mo LEE
1
;
Bock HUR
;
Hyeon Cheol KIM
;
Sung Gwan WOO
;
Kwang Hoon KIM
;
Kwon SON
;
Jeong Kil PARK
Author Information
1. Department of Conservative dentistry, College of Dentistry, Pusan National University, Korea. jeongkil@pusan.ac.kr
- Publication Type:Original Article
- Keywords:
Occlusal load;
Stress distribution;
Finite element analysis;
Maxillary second premolar;
Compressive stress;
Tensile stress
- MeSH:
Bicuspid;
Dental Enamel;
Finite Element Analysis;
Tooth Cervix
- From:Journal of Korean Academy of Conservative Dentistry
2006;31(6):427-436
- CountryRepublic of Korea
- Language:English
-
Abstract:
The objective of this study was to investigate the effects of various occlusal loads on the stress distribution of the buccal cervical region of a normal maxillary second premolar, using a three dimensional finite element analysis (3D FEA). After 3D FE modeling of maxillary second premolar, a static load of 500N of three load cases was applied. Stress analysis was performed using ANSYS (Swanson Analysis Systems, Inc., Houston, USA). The maximum principal stresses and minimum principal stresses were sampled at thirteen nodal points in the buccal cervical enamel for each four horizontal planes, 1.0 mm above CEJ, 0.5 mm above CEJ, CEJ, 0.5 mm under CEJ. The results were as follows 1. The peak stress was seen at the cervical enamel surface of the mesiobuccal line angle area, asymmetrically. 2. The values of compressive stresses were within the range of the failure stress of enamel. But the values of tensile stresses exceeded the range of the failure stress of enamel. 3. The tensile stresses from the perpendicular load at the buccal incline of palatal cusp may be shown to be the primary etiological factors of the NCCLs.
