Finite element analysis of revision prostheses for tibial bone defects with different lengths of tibial stems
10.3760/cma.j.cn121113-20230615-00331
- VernacularTitle:不同长度胫骨柄的胫骨侧骨缺损翻修假体的有限元分析
- Author:
Weijie ZHANG
1
;
Yongchang GAO
;
Zhicheng AN
;
Shibin CHEN
;
Shuxin YAO
;
Jianbing MA
Author Information
1. 西安交通大学附属红会医院关节病医院膝关节病区，西安 710054
- Keywords:
Reoperation;
Bone remodeling;
Prosthesis design;
Finite element analysis
- From:
Chinese Journal of Orthopaedics
2024;44(4):260-269
- CountryChina
- Language:Chinese
-
Abstract:
Objective:To evaluate the mechanical performance of customized metal prosthesis with tibia stems of varying lengths for tibial bone defects reconstruction.Methods:Morphologically matched postoperative finite element models of bone defect revision were developed, with three gradients (15 mm, 30 mm, and 45 mm) according to the degree of bone defect and were reconstructed with 3D printed tantalum metal prosthesis using three tibial stem lengths (80 mm, 120 mm, and 150 mm), respectively. Conventional static and dynamic (walking gait) loading was performed to analyze the peak tibial stress distribution and accumulated sliding distance at the prosthetic interface, and to assess the effects of the three tibial stems of different lengths on the stability of the customized tibial defect restorations and the internal tibial stress state.Results:The peak accumulated sliding distance of the dynamically loaded morphologically matched restorations ranged from 17.94 to 21.31 mm with static loading, which were 68% to 84.3% higher than those of 10.26 to 11.69 mm with static loading. The peak tibial stresses in the dynamically loaded model were greater than those in the statically loaded model, with an increase of 28%-49.2%, including 132.94-143.88 MPa in the statically loaded model and 170.41-200.14 MPa in the dynamically loaded model. The overall accumulated sliding distance of the tibia prosthetic model gradually decreased from the tibial osteotomy surface, and the accumulated peak sliding distances ranged from 10.26 to 11.69 mm for static loading, and from 17.94 to 21.31 mm for dynamic loading. The bone tissue stresses in the anterolateral and medial-posterior tibia increased gradually from top to bottom, and the maximum stress value in each section was in the posterior medial tibia (the maximum value was 200.14 MPa). The highest bone tissue stress in the lateral tibia was affected by the tibial stem length, which resulted in a different location, and it was the area most affected by stress shielding (maximum value of 170.65 MPa).Conclusion:For stability assessment of morphologically matched tantalum customized prosthesis, physiological gait dynamic loading studies are more reliable than static loading; the choice of tibial stem length depends on a combination of accumulated peak sliding distances and tibial bone stress distribution factors.
