The consistency of tomographic infrared spectroscopy with conventional infrared spectroscopy for the analysis of the composition of larger-volume urinary calculi
10.3760/cma.j.cn112330-20211208-00635
- VernacularTitle:断层红外光谱法与常规红外光谱法对较大体积泌尿系结石成分分析结果的一致性
- Author:
Bixiao WANG
1
;
Lei LIANG
;
Jinting LI
;
Yuxiang XING
;
Chaoyue JI
;
Bo XIAO
;
Hongmei JIANG
;
Jianxing LI
Author Information
1. 清华大学附属北京清华长庚医院泌尿外科 清华大学临床医学院，北京 102218
- Keywords:
Urolithiasis;
Component analysis;
Infrared spectroscopy;
Tomography;
Calcium oxalate
- From:
Chinese Journal of Urology
2022;43(10):770-777
- CountryChina
- Language:Chinese
-
Abstract:
Objective:To compare the consistency of tomographic infrared spectrum analysis with conventional infrared spectrum analysis for the composition analysis of large-volume of urinary stones in vitro.Methods:Postoperative urinary stone specimens collected from 105 patients admitted to Beijing Tsinghua Changgung Hospital from January 2019 to June 2021 were analyzed, including 81 (77.14%) kidney stones, 16 (15.24%) ureteral stones, and 8 (7.62%) bladder stones. All stones measured ≥0.8 cm in maximum diameter on preoperative imaging. Eighty-four specimens, which were mainly stone fragments, were collected from percutaneous nephrolithotomy and ureteroscopic lithotripsy. These 84 specimens were analyzed and retested for stone composition using conventional infrared spectrum analysis by random multiple sampling. Other 21 renal stone specimens were obtained by laparoscopic lithotomy or standard percutaneous nephrolithotomy after November 1, 2020. These 21 specimens had a maximum diameter of ≥0.8 cm measured postoperatively. Based on intraoperative observation, stone specimens with typical layered structures were chosed. Then, all 21 samples were analyzed and retested by conventional infrared spectrum analysis and tomographic infrared spectrum analysis, respectively. When using tomographic infrared spectrum analysis, we need to take two maximum cross sections with a vertical spacing of these sections >2 mm, then perform multiple points sampling according to the morphological stratification of the first section. If the section's structure was homogeneous, we equidistantly took 2 to 3 samples from the center to the periphery. Otherwise, every layer needed to take a stone sample according to the stratification. Putting all the results of one section together, we obtained complete tomographic infrared spectrum analysis data. Take another coaxial cross-section of the same specimen for retesting. We recorded the characteristics of the three-dimensional distribution of stone composition in 21 stone specimens. Meanwhile, we compared the consistency of the results of conventional infrared spectrum analysis and tomographic infrared spectrum analysis for the same sample.Results:The consistency rate of the conventional infrared spectrum analysis was 56.19% (59/105), and that of tomographic infrared spectrum analysis was 80.95% (17/21). The difference in consistency between two methods was statistically significant ( χ2=4.447, P=0.035). Among 21 specimens, the consistency rate of conventional infrared spectrum analysis was 38.10% (8/21), which was significantly lower than that of tomographic infrared spectrum analysis ( χ2=7.814, P=0.005). Regarding the characteristics of the three-dimensional distribution of the components, the color and crystal morphology of five common types of stone components were different, and layered structure in the cross-section of the stones were observed. When the calculi were of the same composition, they were displayed in different morphology. We observed a trending change in the composition ratio between sublayers from the center to the edge in some compound-composition stones. Conclusions:For the composition analysis of larger-volume urinary stones, tomographic infrared spectrum analysis showed a higher consistency of retesting than conventional infrared spectrum analysis, and the three-dimensional distribution of stone composition had some characteristic features.
